@sprinklesprinklelittlestar: the screw hole track issue is only on DIY 2.2 — in fact I just checked the PCB design, and the mistake was that the top/bottom keepouts (which prevents traces from running nearby) were slightly shifted from the screw hole, that’s why some PCB traces went too close to the screw hole. But assuming user ‘automate’ has the fully assembled OS 2.1, this is not an issue. In addition, all fully assembled OS have been tested and the initial time on OS is obtained from NTP.
@automate: if you change the time zone manually, that means either you didn’t turn on NTP flag, or you are changing this manually on the controller using buttons. Can you confirm?