I finally built my OpenSprinkler Beaglebone device. Once physically set-up, I booted up the device and got all the updates and got everything programmed via my computer. It appears as if everything works properly. I grabbed a solenoid and connected one lead to the common and one to station 1. I then set it to manually run station 1. Again, it appears as if everything works properly, but nothing happens. I’ve made an educated guess that ~24 VAC should be detected between common and an activated station… is that a correct guess? There is no voltage between between either of the common pins to any of the station pins as I manually change stations from one to the next. Interestingly, there is ~29 VAC between either of the common pins to either of the rain-sensor pins. I’m at a loss as to what to do next.