OpenSprinkler Forums Hardware Questions OpenSprinkler Pi (OSPi) pre-configured SD card image Reply To: pre-configured SD card image

#40610

Datamonkey
Participant

Yes I can SSH in using Putty.
I can’t view the file because as far as I can tell there is not text reader on the image. So I am not sure what is in the index.html file.
I did some reading and tried setting up my WIFI via the command line but it can’t see the TPLINK TL-WN725N. It is saying:

pi@ospi ~ $ ifconfig wlan0 up
wlan0: ERROR while getting interface flags: No such device

I thought this dongle from what I read and in the past that it should load automatically for Raspberry. It was also working before switching to the image.
I guess what my issue is I am not a command line guy and was used to using Xwindows or something like that to do all my set up in the past. So I am stumbling through with this command line setup.

But as long as I am connected via CAT5 I can get to http://x.x.x.x:8080 no problem (Much improvement from the version I was running.) but not http://x.x.x.x/.
If there is nothing on http://x.x.x.x/ that I need for WIFI setup then I will try doing via command line.

Can some one validate if a TPLINK TL-WN725N need drivers installed in this image? Or am I just a completer idiot and I totally going about this wrong.