OpenSprinkler › Forums › Hardware Questions › OpenSprinkler Pi (OSPi) › Voltage staying high on station, valves not closing › Reply To: Voltage staying high on station, valves not closing
February 16, 2017 at 7:19 am
#45413
tomalt
Participant
Instructions say not to use latching solenoids – it’s my understanding the two I have are not latching types but I’m not 100% sure. They’re basically the common ones from the big chain store here (Bunnings Australia).
They are both 24v and activate/open with 24V.
Neither of them mentioned Latching anywhere.
Other than that I’m lost – I really hope nothings wrong with the board because I’d have to ship it back from good old down under and the kangaroos might nick off with it from the post 😉