OpenSprinkler › Forums › Hardware Questions › OpenSprinkler Pi (OSPi) › Anyone Running with a New Raspberry Pi 3+? › Reply To: Anyone Running with a New Raspberry Pi 3+?
June 17, 2018 at 4:49 pm #50733
I saw that I was running firmware 2.1.7 so I justed updated that to 2.1.8 but that didn’t help.
If I disconnect the OS board from the Pi and run
gpio readall I can see that SCL goes high so it does appear that something on my new OS Board is pulling/holding SCL low.
Was I just unlucky and received a defective OS board?