Hello (from Australia)
I’ve just purchased/installed OpenSprinker (as a replacement for old Hunter controller) with an Ethernet module (as wifi would be at edge of range)
In the middle of initial setup – I found controller looping thru a boot sequence – removed Ethernet connection & able to gain access via Wifi.
Based on guidance in this thread, I have changed Port from 80 to 8080
I have had another 2 lockups (buttons till work) while using Ethernet – so reverting to Wifi awaiting guidance on what to try next
Hardware Version is 3.2 – AC Firmware is 2.1.9 (9)
Regards
Colin