compiles fine, screen doesn’t work. AP mode works, add my ssid etc, then reboots back to ap mode. Seems chip is warmer than with 2.1.9 original working firmware?
Started update server
— MQTT Init
2106-02-07 01:28:34 – MQTT Init
2106-02-07 01:28:34 – MQTT Init: ClientId OS-A0B7654CB00C
Starting AP
Starting AP with SSID OS_4CB00C
Connecting in AP_STA to WiFi network Cisco
IP received by client, restart.
Prepare to restart…
ets Jul 29 2019 12:21:46
rst:0xc (SW_CPU_RESET),boot:0x17 (SPI_FAST_FLASH_BOOT)
configsip: 0, SPIWP:0xee
clk_drv:0x00,q_drv:0x00,d_drv:0x00,cs0_drv:0x00,hd_drv:0x00,wp_drv:0x00
mode:DIO, clock div:2
load:0x3fff0030,len:1184
load:0x40078000,len:13192
load:0x40080400,len:3028
entry 0x400805e4
Build timestamp: Jun 5 2023 20:20:19
— Starting setup
Scanning i2c for devices…
No I2C devices found
Using GPIO IOEXP
Starting to detect expanders
hw_type = 172 hw_rev = 0
Starting sensors – INPUT_PULLUP
Sensor1 PIN: 36
Sensor2 PIN: 2
Starting RFTX pins
RFTX PIN: 255
LCD SSD1306 init
Init file system…
Flash size: 4194304 bytes
Done.
Detecting RTC…done.
— Setting up options
Factory reset
[ 16117][E][WiFiAP.cpp:141] softAP(): SSID missing!
Starting AP with SSID
— PD init
— Time setup
Starting network
ETH enabled: 0
Wifi mode: AP
OTF start with http_port 80
Started OTF with just local connection
DNSServer start
Setting update server
Starting MDNS service
[ 18814][E][ESPmDNS.cpp:148] addService(): Failed adding service _http._tcp.
[ 18815][E][ESPmDNS.cpp:169] addServiceTxt(): Failed setting service TXT
Started update server
— MQTT Init
2106-02-07 01:28:34 – MQTT Init
2106-02-07 01:28:34 – MQTT Init: ClientId OS-A0B7654CB00C
Starting AP
Starting AP with SSID OS_4CB00C