I think there is an issue with this too. I have
zone 1 starting at 4:00 AM, run for 15 minutes, with a 1439 minute interval, off at 8:00 AM (program 1)
zone 2 starting at 4:01 AM, run for 30 minutes, with a 1439 minute interval, off at 8:00 AM (program 2)
zone 3 starting at 4:03 AM, run for 20 minutes, with a 1439 minute interval, off at 6:00 AM (program 3)
zone 4 starting at 4:03 AM, run for 20 minutes, with a 1439 minute interval, off at 6:00 AM (program 3)
When looking at the program preview, these programs show up as all overlapping, except for program 3 which shows zone 3 running then zone 4. I thought that the zones and programs were both supposed to run sequentially?
Ideally I think I should be able to set them all to wtart at 4:00 AM and the software would determine which zone to run first and to run them sequentially. It could even be “smart” and look to see if zone 3 and 4 need to be off earlier than zones 1 and 2 (don’t like to run zones while dog is in the yard), then it could actually start with zone 3, then 4, then 1, then 2.