OpenSprinkler › Forums › Hardware Questions › OpenSprinkler Pi (OSPi) › OpenSprinkler PI – (small) fuse burned › Re: Re: OpenSprinkler PI – (small) fuse burned
August 31, 2014 at 2:11 am #28027
The fuse is a solder-on type. Do you have a soldering iron? If so, you can clip and desolder the existing fuse, and solder a new one. You can send an email to [email protected] to arrange for support.
Because the fuse is connected on the COM wire, it’s likely you may have a shorted solenoid, or for some reason the solenoids are drawing more than 2 amp of current that triggered the fuse. So make sure to check your solenoids before trying again.