OpenSprinkler › Forums › Hardware Questions › OpenSprinkler Beagle (OSBo) › Power to valves stuck on? › Re: Re: Power to valves stuck on?
May 19, 2014 at 1:41 pm #26875
Did you have solenoids connected at all or you are just using a multimeter to measure the voltage with no solenoids connected? If no solenoid, the voltage reading is normal, due to stray voltage. When you have a load connected it should remain off (close to 0 voltage).
I’ve measured the voltage both ways – with and without solenoids connected. The voltage is always the same across all stations.