OpenSprinkler › Forums › Hardware Questions › Programs don’t run when they should › Re: Re: Programs don’t run when they should
July 9, 2013 at 11:25 pm #24729
Hmmm…I was reviewing the user manual to see if it offered any hints, and I noticed that I am missing the “run once” button. I also see that my home page is the “manual operation” as opposed to the “status” page. In fact, I can’t seem to find the status page shown in the manual.
Is it possible the system is locked into manual mode? The “manual” button on the bottom of the page shows “off”, but I’m wondering if it is wrong.
I’m running firmware version 2.0.0, and this is the Arduino system, if that helps.