OpenSprinkler › Forums › Hardware Questions › Router Causes clock to jump back › Re: Re: Router Causes clock to jump back
August 6, 2014 at 9:07 pm #27514
Double checked the battery again just to make sure. It is in correctly (I can read the + when I look at the board) and I am still getting 3v on one pin of a small 8-pin chip on the board indicating that the solder connections are good.
Also, the station 5 “ON” icon (expanding bubble) starts off ok, but after a few minutes gets VERY slow indicating something besides (or in addition to) thew RTC problem. You can see two videos of the problem at: