OpenSprinkler Forums Hardware Questions DIY Kit Assembly Questions Trouble powering 1.42u with 24vac Re: Re: Trouble powering 1.42u with 24vac



Oh Man,

That was it. The resistor arrays were swapped around.

Ray, not your fault but I got confused by the text:
“For example, 10K array should read ‘L83S 103 xxxx’, “

I think i read the first part of the label L83S and made the [wrong] assumption that the resistor i was holding was the10k and i labeled it as such while doing the parts check.

Because they are so similar, It would have been super hand if those were distingushed in the kit.

But then again i am the only numbskull that made that mistake. I broke one of the arrays desoldering so i am waiting on an order from digi-key.

I’ll let you know how it turns out.

Thanks for your help everyone.