- This topic has 2 replies, 2 voices, and was last updated 8 years, 9 months ago by
.
Viewing 3 posts - 1 through 3 (of 3 total)
-
Posts
-
I’m replacing a RainBird ESP-Me controlling 11 zones (wiring photo attached) with an OSPi + an Expansion Board.
I’d like to keep the physical zone numbering consistent with the original wiring so that it will match the diagram from the installer.
Is there any reason that I cannot/should not map the MV to a port on the Expansion Board, say, on zone 12?
Attachments:
You can map the MV to zone expander. OpenSprinkler firmware now supports using any available zone, including those on expansion boards, as master zone/valve.
Viewing 3 posts - 1 through 3 (of 3 total)
- You must be logged in to reply to this topic.