- This topic has 4 replies, 3 voices, and was last updated 7 years ago by
.
-
Posts
-
Just noted that pulse flow meters are going down to affordable prices. 2-wire Hunter HC-075-FLOW 3/4″ FNPT Flow Meter at $88 from Sprinkler Warehouse. 1-inch size is about $20 more.
RainBird has finally got into the niche market with their own FMD Series Landscape Water Meters. Haven’t seen the price but it’s probably not the cheapest one.
As I noted before, it’s hard to beat the price of EKM Metering’s stainless steel ($70) 3/4in. pulse output meters. They were one of the first to offer these kinds at a low price and they are California-certified for potable systems. Wire it up to a pulse transmitter w/gateway device and you can get high-flow and low-flow detection with SMS alarms independent of controller itself.
Search for pulse water meter suppliers. Some are cheaper (https://www.flows.com at $69) but that’s with no pulse output.
I should add that a reed switch add-on is going for $20 from Assured Automation so it can be screwed onto their $69 plastic meters.
Just received Flow.com’s low cost (plastic) water meter with dry-contact reed switch (2-wire) pulse output made by Assured Automation. Tested unit with pulse counter to confirm that 1 pulse = 1 gallon. Very good product. This ought to be a perfect match for opensprinkler flow sensor connectors. Because there were some fractional scaling issues when calibrating pulses to GPM with the Hall-effect sensors in opensprinkler’s software settings. That should be no longer an issue with this particular meter (WM-PC series)
IMHO trying to monitor fractions of gallons of water flow is overkill for an irrigation system, even if you’re using just microsprays and small misters. Typically the 3-wire Hall-effect flow sensors are going to do that because they’re not designed for large flows as you typically have in irrigation. They’re better at metering precision with smaller flow. Plus if you’re using batteries to get signal, it’s a non-stop chore to keep swapping out batteries when you lose pulse output. Reed switches don’t need to be powered to produced pulses.
- You must be logged in to reply to this topic.