- This topic is empty.
-
Posts
-
Hello everyone … Today I also installed the Zone Expansion Board on my OpenSprinkler PI.
All right, but after a few minutes it burned the small fuse near the AC connector.
How can I fix? You should replace the fuse, but I can not remove it … How can I do?
Thank you and hello !!
The fuse is a solder-on type. Do you have a soldering iron? If so, you can clip and desolder the existing fuse, and solder a new one. You can send an email to [email protected] to arrange for support.
Because the fuse is connected on the COM wire, it’s likely you may have a shorted solenoid, or for some reason the solenoids are drawing more than 2 amp of current that triggered the fuse. So make sure to check your solenoids before trying again.
Thanks Ray!
My mistake … I have two cables to connect an expansion, with 24 zones .. I made a mistake and I connected the cable to the AC zone3.
Luckily there is a fuse, or burned the card!I do not have a soldering iron, but I organize. What size fuse should I buy?
Thanks for your support!
regards
If you can email to [email protected] we will arrange to send you a few.
- You must be logged in to reply to this topic.