I encountered the same problem where the first zone ran, but the rest didn’t. I verified by checking to see if there was water outside and there wasn’t. The log shows that the 1 zone ran, but nothing else. I had reformatted the MicroSD card after the 2.1 upgrade.
My log looks like this:
<pre style=”color: #000000; line-height: normal; word-wrap: break-word; white-space: pre-wrap;”>[[1,0,180,1415084581]]
My configuration is as follows:
<pre style=”line-height: normal; word-wrap: break-word; white-space: pre-wrap;”>{“programs”:{“nprogs”:5,”nboards”:1,”mnp”:14,”mnst”:4,”pnsize”:12,”pd”:[[65,74,0,[420,-1,-1,-1],[180,0,180,0,0,0,0,0],”Front Plants”],[65,10,0,[420,-1,-1,-1],[0,180,0,0,0,0,0,0],”Front Trees”],[65,8,0,[420,-1,-1,-1],[0,0,0,0,300,0,0,0],”Rear Beds”],[65,74,0,[420,-1,-1,-1],[0,0,0,0,0,300,0,0],”Rear Planter”],[65,66,0,[420,-1,-1,-1],[0,0,0,180,0,0,0,0],”Rear Trees”]]},”stations”:{“snames”:[“Front Middle”,”Front Trees”,”Front Near House”,”Rear Trees”,”Rear Raised Beds”,”Rear Planters”,”S07″,”S08″],”masop”:[255],”ignore_rain”:[0],”act_relay”:[0],”stn_dis”:[192],”maxlen”:16},”options”:{“fwv”:210,”tz”:16,”ntp”:1,”dhcp”:0,”ip1″:10,”ip2″:0,”ip3″:1,”ip4″:111,”gw1″:10,”gw2″:0,”gw3″:1,”gw4″:1,”hp0″:80,”hp1″:0,”ar”:1,”ext”:0,”seq”:1,”sdt”:0,”mas”:0,”mton”:0,”mtof”:0,”urs”:0,”rso”:1,”wl”:100,”den”:1,”ipas”:0,”devid”:0,”con”:110,”lit”:100,”dim”:5,”rlp”:0,”uwt”:0,”ntp1″:204,”ntp2″:9,”ntp3″:54,”ntp4″:119,”reset”:0,”dexp”:0,”mexp”:5},”status”:[0,0,0,0,0,0,0,0],”settings”:{“devt”:1415087560,”nbrd”:1,”en”:1,”rd”:0,”rs”:0,”rdst”:0,”loc”:”San Diego, CA”,”wtkey”:”36716e4595294efd”,”sunrise”:369,”sunset”:1014,”sbits”:[0,0],”ps”:[[0,0,0],[0,0,0],[0,0,0],[0,0,0],[0,0,0],[0,0,0],[0,0,0],[0,0,0],[0,0]],”lrun”:[0,0,0,0]}}
Any suggestions?
Thanks!