Log In Register

OpenSprinkler › Forums › OpenSprinkler Unified Firmware › RF control using more than one frequency

Tagged: 

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • September 2, 2017 at 7:06 pm #47580

    bobby2
    Participant

    I know there is only one place on the circuit board for one RF transmitter. Is there support built in the software for additional RF transmitters installed on different pins for transmitting on different frequencies? Thanks.

    September 18, 2017 at 8:14 am #47755

    Ray
    Keymaster

    The firmware only supports one RF transmitter at the moment. It should be pretty straightforward to extend it to two RF transmitters, by basically duplicating the firmware code for the current RF transmitter.

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.

OpenSprinkler › Forums › OpenSprinkler Unified Firmware › RF control using more than one frequency