- This topic has 2 replies, 2 voices, and was last updated 7 years, 8 months ago by
.
-
Posts
-
I’ve so far had luck upgrading my DIY 2.1 to 2.1.7 using the precompiled hex from 2.1_ext.
Would it work with swapping out the dip chip? What gotchas should I be aware of if I were to go this route? I’d like to keep a boot loader, because the ISP pins are not very reachable/usable, and I had to break out my connector to connect my USBTinyISP to it for programming.
I don’t think it would work — while 1284 is pin compatible with 644, the circuit on OS 2.1 has no built-in USB-serial chip — it assumes the bootloader on the chip is the USBasp bootloader. Unfortunately there is no USBasp bootloader for 1284, it’s only for 644. So even if you replace the chip, there is no available bootloader for it to work — you would still need to program it using ISP.
- You must be logged in to reply to this topic.