Log In Register

OpenSprinkler › Forums › Hardware Questions › OpenSprinkler Pi (OSPi) › OSPI HW test code

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • March 14, 2025 at 4:06 pm #81582

    vinthewrench
    Participant

    I am developing (yet another) farm automation program (it will be open source) and would like to pick up the OSpi board. by any chance did you publish your board test code? I can dig through openprinkler to figure out how the HW works, but it would be nice if the HW validation code was around?

    specifically I get that the Solenoid drivers are connected through a 74595 and that you have an A/D available, and that you have some buttons on GPIO18/24/10 and some other?

    Maybe is there a HW document?

    many thx

    March 15, 2025 at 7:01 am #81587

    Ray
    Keymaster

    The OSPi board does not have a built-in microcontroller so the test code is not in the firmware since the firmware will have to run on a RPi. We have a dedicated OSPi tester, which is based on a ATmega microcontroller. It runs basic testing code including testing each zone, button, and LCD etc.

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.

OpenSprinkler › Forums › Hardware Questions › OpenSprinkler Pi (OSPi) › OSPI HW test code