- This topic has 1 reply, 2 voices, and was last updated 10 months, 1 week ago by
.
Viewing 2 posts - 1 through 2 (of 2 total)
-
Posts
-
When I installed the Pi on the OpenSprinkler PI board I noticed a very close fit between the SD card on the Pi and a component on the OpenSprinkler Pi board. Photo attached. In my case it did fit and everything worked fine, but it wouldn’t take much of a shift on that component to cause a contact.
Attachments:
Viewing 2 posts - 1 through 2 (of 2 total)
- You must be logged in to reply to this topic.