OpenSprinkler Forums OpenSprinkler Mobile and Web App Analog sensor program time adjustment

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #81701

    [email protected]
    Participant

    Hello, I have recently installed two mqtt soil moisture sensors, added them to group, set-up the program adjustment and in the Analog sensor section it all looks just fine – the moisture is calculated and the adjustment in the program time shown in the respective chart.
    Nevertheless on the main page i still see the “water level” calculated according to the Weather data and in program preview I see the times according to weather data.

    Please, what is the correct setup to ignore the weather data and take into account the soil moisture only?

    Thank you

    #81706

    Ray
    Keymaster

    It looks like you are using the firmware developed by our German distributor Stefan. Since the analog sensor features are written by him (our firmware does not support this yet), please direct your questions to their forum.

    #81707

    [email protected]
    Participant

    Ok, thanks! 🙂

Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.

OpenSprinkler Forums OpenSprinkler Mobile and Web App Analog sensor program time adjustment