- This topic has 1 reply, 1 voice, and was last updated 5 years, 8 months ago by
.
Viewing 2 posts - 1 through 2 (of 2 total)
-
Posts
-
I found a schematic
https://github.com/rayshobby/opensprinkler/blob/master/Expansion%20Board/exp20.png
but it shows 2 pin connectors for all zones and doesn’t show 2.2 ohm resistors. My case is marked v1.1. The PCB is marked v2.1. Is a schematic available? A bill of material? One of the 2.2 ohm resisters is burned – I suspect it may be from a bad valve.Found it here:
https://github.com/OpenSprinkler/OpenSprinkler-HardwareSure would be nice to be able to get the schematic and BOM without having to install Eagle…
Viewing 2 posts - 1 through 2 (of 2 total)
- You must be logged in to reply to this topic.