- This topic has 3 replies, 2 voices, and was last updated 8 hours, 27 minutes ago by
.
-
Posts
-
I updated the firmware in my OpenSprinkler, and then restored the backup. But it didn’t restore properly, there are no names on the stations (see screenshot attached). I’ve also attached the backup I used when I updated. The backup has been renamed to .txt since the board doesn’t like a .json file uploading.
Attachments:
It’s possible the import got disrupted for some reason. You can modify the .json file, leaving only the stations data, and just import that, see if it works. I attached the modified .json file here. It’s the original json with all sections other than “stations” removed.
Well, I got the same error about uploading file, so here is the file content:
{"stations":{"masop":[255,255,255],"masop2":[0,0,0],"ignore_rain":[0,0,0],"ignore_sn1":[0,0,0],"ignore_sn2":[0,0,0],"stn_dis":[2,128,255],"stn_spe":[0,0,0],"stn_grp":[0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0],"snames":["Lawn","Front Yard","Ferns","Retaining Wall","Driveway","Dry Creek Bed","S07 - Unused","S08 - Unused","Hill #1","Hill #2","Hill #3","Hill #4","Hill #5","Hill #6","Hill #7","S16","S17","S18","S19","S20","S21","S22","S23","S24"],"maxlen":32}}Hmm, importing that file gives an “Invalid Configuration” error.
I saved the above with a .json extension.
Poking around further, it looks like most of the run times for the stations were correctly re-imported, but the section for Tuesday didn’t come in correctly. See screenshot.
Attachments:
- You must be logged in to reply to this topic.