[Canute]

Thanks for the work-around Ray. That should do the trick. I realize i am probably one of only a few that need this granularity. I appreciate all your hard work and time put in to make this such a versatile timer.
Cheers!

[Canute]

I see. The main reason i chose this timer was because it is programable in seconds. It was one of only a couple others that i found. I wound up loving it for many other reasons as well but if it can’t do seconds over a minute then i’m going to have to move on. I use seconds for each stations from 30-45 depending on the plants demand. Yes 5 seconds makes a huge difference. I just recently changed one of my systems which has lower pressure and now needs to program for 55sec- 1min 10sec. At this time i also updated my firmware only to discover this change which has severely dampened my 10K watering system. I have also turned a handful of others onto this timer, one of which builds systems for his clients using this timer. I hope the microSD card allows you to revert back to full control otherwise this is just another minute timer.
thx

[Canute]

I tried the parallel workaround. It would have worked perfect except when you program a station with minutes you can no longer use seconds in addition. Why are we being limited now? My 8 stations have to add up to whole minutes so the parallel master runs the same time as the 8 stations.

[Canute]

I have a similar situation as described by a couple other users. I have 8 zones that i need to alternate watering between two different sources. I need to feed all 8 zones from a ‘nutrient’ source and then feed all 8 zones from a ‘flush’ source. The workaround described above won’t work because i have too many zones. I will try the parallel workaround next. Just hoping this is being worked on for the next update? Two master valves that can be controlled within a program and associated with any zone. Thx!

[Author]

Posts