Forum Replies Created

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • in reply to: level sensor question #75282

    Eric Moran
    Participant

    Ray,

    Thank you again for your time and it is greatly appreciated. Especially with tracking down the lines of each file to start at. You have answered my questions, for where to start. I will reach out if I run into any roadblocks.

    Thank you again.

    Kindly,
    Eric

    in reply to: level sensor question #75278

    Eric Moran
    Participant

    Ray,

    Thank you for the quick response.

    When you say “Sensor/switch controls whether a programs runs or not”. Does that mean that if a program is set to run for 30 seconds, and that program is triggered by a toggle switch, and that switch is activated, the program will continue to re-run until the switch is deactivated? Or does that mean that once the switch is activated the program runs once and needs to be reactivated to run the program again?

    I do appreciate that the code is opensource, and the work that has gone into it. With that said, I am not that good with coding. Most of what I do is either copy and paste or 30 lines or less. I wouldn’t know where to begin to edit your code.

    So what I guess I a trying to say is, if a switch being activated will continue to trigger a program (as long as the switch stays active), then I can work with that. If a switch being active will only trigger the program once, regardless of the switch still being active, thent would be easier for “me” to modify my code to send 2 second pulses instead of a steady on or steady off.

    Again, thank you for your time and efforts.

    Kindly,
    Eric

Viewing 2 posts - 1 through 2 (of 2 total)