Forum Replies Created

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • April 8, 2015 at 1:33 pm in reply to: Is the API working on firmware 2.1.3? #36559

    Jared
    Participant

    That makes sense, thanks! I guess I missed the post, is the user manual going to be updated as well?

    April 5, 2015 at 7:56 pm in reply to: Is the API working on firmware 2.1.3? #36495

    Jared
    Participant

    I’m also seeing a problem. It seems like it isn’t able to authenticate the password. I’m trying to update the script url: http://{ipaddress}/cu?pw={password}&jsp={newscripturl}, and I get the same {“result”:2} response.  If I go into Options->Advanced and select “Ignore Password”, then it works.

    I’m using OpenSprinkler hardware rev 2.3.

    March 27, 2015 at 12:31 pm in reply to: Hardware Rev 2.3 #36309

    Jared
    Participant

    Thanks!

    March 26, 2015 at 7:14 pm in reply to: Hardware Rev 2.3 #36283

    Jared
    Participant

    As I looked into the previous relay implementation, I see that it was driven from D6 with a npn driver, so I should try to replicate thay with a 5vdc relay rather than a 24vac relay.

    It’s hard to tell for sure by looking at the board, but it doesn’t look like this pin is brought out to any through-hole contacts. Would I need to solder directly to the uC pin?

    Ray, can you upload the latest schematics to github? Also, were there any FW changes for this HW rev? Or will it still control this pin if selecting activate relay for a station?

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)