[oldmate32]

Thanks Ray, I will adjust the values using the buttons to get me up and running.

[oldmate32]

Hi, I notice in the app the master on and off delay setpoint limits are 60sec, whereas the manual says the range should be 600sec. Was this changed for 2.1.9? Is it possible to change it back to 600sec?

The longer time of 600sec would be good for my application. I’ve got an air intake on the manifold to prevent siphoning into dripper line. I turn the master off and leave the zone open for an extended period to allow the line to drain via the air intake, rather than sucking dirt into the higher drippers as the line empties via gravity.
Cheers

[oldmate32]

Thanks for the reply Ray. Yes, just as I thought. I guess the ‘tight’ fit could help if the board had to go through a wave solder process and keep the header from tilting.
Cheers
Tim

[Author]

Posts