Forum Replies Created
-
Posts
-
@ray wrote:
@rok: if the cable becomes unreliable, you can send an email to [email protected] to request a new set of cables.
Thanks ray. I buyed a new one. I am from germany. I think the shipping cost are more expensive than the cables 😉
Got it!
It was that damn connection cable between Raspberry and the Pi board. Fixed it and it works!!Uhm, sorry. I have no glue about all that things 😳
Could you please explain it for a noob like me?@nayr wrote:
a multimeter set to VAC to check for voltage across COM and the station that is on is how you test the unit is switching.
This was the first one in my test. No voltage change, if I manually switch on by webinterface.
@nayr wrote:
did you have your system winterized? have you gone through opened all the valves and turned the water back on? It takes a several mins to refill my lines every spring before enough pressure builds to push the heads up and theres several valves that need opened and a few that need closed.. just booting the sprinkler back up in the spring usually isint enough.
The valves and sprinklers working well. I tested it by attaching the valve cables on the power supply.
@ray wrote:
After the winter season, yesterday I’ve activated my OSPi, connected to the web interface and tried to manually switch on one of the zones. Nothing happens. No switching, no water, no error message in the log. What’s going wrong here? Is there a problem with the hardware? How can I test/fix it?
rokI assume you are using the sprinklers_pi program for manual control, is that right? Which version of OSPi do you have?
Hi ray!
I am using the alternative webinterface (1.0.6 – updated to 1.0.7) from Richard Zimmermann.
Should I try it on the root-console? Could you tell me how to do it?Hi!
Last year everything works fine. After the winter season, yesterday I’ve activated my OSPi, connected to the web interface and tried to manually switch on one of the zones. Nothing happens. No switching, no water, no error message in the log. What’s going wrong here? Is there a problem with the hardware? How can I test/fix it?
