OpenSprinkler › Forums › Hardware Questions › OpenSprinkler Pi (OSPi) › 1st time install and setup › Re: Re: 1st time install and setup
April 17, 2014 at 3:34 am
#26494
karmaman
Member
Thanks, I’ll give that a try. Can I apply the pre-configured OSPi SD card image to the NOOBS image after I’ve completed the NOOBS setup?
One more question – I have 9 sprinkler zones and thus have the extension board connected to my OSPi. When I access the OSPi through the browser, only stations 1-8 are shown. Is there configuration required to make the next block accessible?
Thanks again for your help. I clearly have a lot to learn.