OpenSprinkler › Forums › Hardware Questions › 2.1u Buttons and RJ45 not working › Reply To: 2.1u Buttons and RJ45 not working
cuteboi
After troubleshooting, I wasn’t able to get the buttons to output anything during the “connecting…” phase. Once it completed after several minutes, the buttons were working, I tried all the combinations, the ip address was 0.0.0.0:80, and all blank. Seems like I can’t use buttons until the device has completed initializing. I’ll look fr a new ENC28J60, I see it’s quite common as far as the chipset goes, but the form factor isn’t. Would you happen to have the name of the form factor we are using in the DIY kits? I’ll definitely go and a get new ethernet controller along with the crystal while I’m at it.
Regards,
Anthony