Log In Register

OpenSprinkler › Forums › OpenSprinkler Unified Firmware › Appears to update but doesn't ?

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • October 25, 2015 at 10:30 pm #40613

    mickeyshowers
    Participant

    My OSpi is reporting 2.14. I followed the update instructions but it still reports 2.14. Did a git pull again but it says I’m up to date. Where should I start looking?

    November 1, 2015 at 10:36 pm #40647

    Ray
    Keymaster

    After git pull, make sure to run ‘./build.sh ospi’ to compile the firmware, and either restart RPi (or do sudo /etc/init.d/OpenSprinkler.sh restart) to restart the firmware.

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.

OpenSprinkler › Forums › OpenSprinkler Unified Firmware › Appears to update but doesn't ?