Log In Register

OpenSprinkler › Forums › Hardware Questions › DIY Kit Assembly Questions › Battery Holder

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • March 6, 2015 at 12:23 pm #35846

    Rick
    Participant

    I just completed the soldering of the kit.  This included the battery holder, which I matched to the silk screen.  Upon completion I noticed that it is reversed in comparison to the instruction images.  Before proceeding, I would like clarification.  I have attached an image of my board.

    Thank You

    Rick Harms

    Attachments:

    1. IMG_20150306_070913.jpg

    March 6, 2015 at 1:01 pm #35848

    Rick
    Participant

    Never mind.  I just saw the picture on the first page of the instructions, it matches mine.  Sorry for the bother.  Apparently there was a board change. Earlier boards, as evidenced by the images later in the instructions are reversed.

    Thank You

    Rick Harms

    March 6, 2015 at 10:56 pm #35858

    Ray
    Keymaster

    You are right — the version you have is a slightly updated version 2.2u (basically adding a hardware MAC address chip).

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.

OpenSprinkler › Forums › Hardware Questions › DIY Kit Assembly Questions › Battery Holder