Viewing 1 post (of 1 total)
  • Author
  • #66554


    I see the app shows the current drawn when a valve is on.
    Is there a way to configure a current limit?

    I recently had a solenoid partially short so it drew 3.5A when on.
    That burned out my power supply, and the replacement before I figured out what was going on.

    It would be great if you could configure the OS3 to shut valves off if the current exceeds a limit, which one would presumably configure to match the capacity of your power supply. I looked through the configuration options and manual, but I didn’t see a way to set such a limit now.

Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.