disabled program gets executed

[krimskrams]

Hi, I have a OpenSprinkler running which works basically fine, however I have one minor issue: As I have a switch connected to OpenSprinkler (see my old post https://opensprinkler.com/forums/topic/master-valve-for-pump-start-relay-and-using-a-button-to-switch-pump/ ) I have defined program 1 but set it to disabled aka. not enabled, see attached screenshot for the program defintiion. It should only run if initiated manually through the switch.

I now observed that this program gets executed (and shows up in the logs of OpenSprinkler) even though no-one used the switch.

Any clue how what happens here and how I can prevent OpenSprinkler from exceuting the program?

Thanks, krimskrams

Attachments:

1. 

   OpenSprinkler_PR1.png
   

[starkeeper]

Hi there,
it seems that I have the same issue. Have you solved your problem? I’m using the OpenSprinklerPi which hardware are you using?

regards

[Ray]

One thing to keep in mind: the switch, as in a sensor, should be connected between SN1 (or SN2) and GND, not VIN, or COM. This is explained in the OSPi user manual.
https://openthings.freshdesk.com/support/solutions/articles/5000631606-user-manual-opensprinkler-pi-ospi-
If the switch is connected incorrectly, it could be triggering the program to run unexpected.

[Author]

Posts