- This topic has 2 replies, 2 voices, and was last updated 11 months ago by
.
Viewing 3 posts - 1 through 3 (of 3 total)
-
Posts
-
OpenSprinkler 3.x uses ESP8266. ESP8266 doesn’t have quite enough GPIO pins that’s why OpenSprinkler uses PCA9535 IO expander chip.
I just finish the board base on opensprinkler hardware on github. I run into an issue that the esp8266 not bootup. Every time power on the blue led one flash and nothing happen. I flash and test the esp8266 before solder to the board. I had 3.3vdc on Reset pin, 3.3vdc CH_PD, 3.3vdc GPIO16,0 vdc GPIO15 and 3.3vdc GPIO0. Can some one help me out or let me what is the issue it will great help? Thanks.
Viewing 3 posts - 1 through 3 (of 3 total)
- You must be logged in to reply to this topic.