My old OSPI don´t work

[Tobi]

Hello,

I was triying to start the spring, but the Ospi don´t switch on the valve.
Please help me to figure out what´s wrong, on ospi side or perhaps on RPI.

When I start a zone manually no 24 volt comes out to the valves.
After a restart, unforseen all zones has 24volt.

I have firmware 2.1.9(4) in use

I belive I did over wintertime also a re- install of software, because the OSPi was not reachable in my Network.
But because of frozen time, I dont made a test.

Grettings from germany
Tobi

Attachments:

1. 

   Ospi-rotated.jpg
   

[Tobi]

Is there for the first ospies an special firmware necessay?

Regards
Tobi

[Ray]

All versions of OSPi can use the current firmware, there is no separate firmware for earlier versions vs. later versions. Perhaps you can try to upgrade your Raspbian to the current version and also your firmware to the current version too (2.1.9(7) whereas you reported 2.1.9(4) is what you have).

[Tobi]

Hello,

I was able to bring the Opsi back to work with the PI2.

I just screw the RPI on the top and opened the box for the LAN wire little bit.

Thanks

Attachments:

1. 

   OPi-PI2-2-rotated.jpg
   

2. 

   OPi-PI2-1-rotated.jpg
   

[Author]

Posts