Opensprinkler 3.0 reset problem

[olinka]

Hi,

I’m on 2.1.8 firmware and I was trying to switch to AP mode, but the B2 + B3 button combination did not do anything, screen displays: (lswc), but Wi-Fi is not switched to AP.
I tried hard resetting the device, I got the “Factory reset? Yes” mea safe, but the buttons are not working. Device is not responding to any of the buttons. Does not change to no, and it does not do anything if I press B3.
In this state I was able to connect to AI-THINKER access point, and got IP address, but the webpage is not running on the device.
The buttons are working in normal mode.

Please advise,
Oli

[Ray]

If the screen displays lswc, that means you didn’t click the buttons in the correct sequence. I think the AP mode switch is B3+B2, not B2+B3.

[Author]

Posts