OpenSprinkler Forums Comments, Suggestions, Requests OpenSprinkler Pi – 2.2.42 update – issue Resolved

  • This topic has 0 replies, 1 voice, and was last updated 6 years ago by atom.
Viewing 1 post (of 1 total)
  • Author
    Posts
  • #37509

    atom
    Participant

    Resolved see below

    Greetings,

    Updated OpenSprinkler Pi to 2.2.42 yesterday afternoon. Overnight there was a rain event that was detected by sensor (as to be expected). However, today zones that are set to ignore rain sensor, did not start.

    I have tried a run once program and the zone valve shows the time in green but does not start counting down and the Master valve shows in the off state.

    Is anyone else experiencing a similar issue and, is there a fix?

    Thanks.

    PS I know I shouldn’t have updated as everything was working brilliantly prior to update

    Resolution:

    Loaded backup SD card and all good. Then installed the 2.2.42 SD card again as needed a schedule setting. When 2.2.42 card was installed a program that was set to ignore Rain Senor ran. I then tested run once programs and the master kicked in as expected. Going to leave 2.2.42 installed and monitor tomorrow.

    Possibly it was the power cycling that resolved the issues. Apart from that, I am not sure.

     

     

Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.

OpenSprinkler Forums Comments, Suggestions, Requests OpenSprinkler Pi – 2.2.42 update – issue Resolved