Program runs just the 1st station

[GatHobort]

Hello,

I am quite new to the OpenSprinkler – using it for a 3 weeks now.

I have a program which is supposed to run my 4 stations sequentially.
When I preview the program it shows all the 4 stations will run in the night.

When I check the logs next morning I see that just the 1st station did run.
When I run the program manually it runs as expected with all the 4 stations.

To make things even more mysterious, sometime all the 4 stations run in the night but that happens very few times only.

Any deeper log I can have a look at, or any clue is highly appreciated.

Thank you

App Version: 2.2.0
Firmware: 2.1.9 (2)
HArdware Version: 3.2 – DC

[Ray]

This is typically because some zone is drawing too much current when opening, causing the power supply voltage to drop significantly, thus triggering a reboot of the controller. An easy way to tell is to unplug the zone terminal block, let the controller run without physically connected to the zones, and see if this still happens.

[Author]

Posts