OpenSprinkler Forums Hardware Questions OpenSprinkler Pi (OSPi) Station one failed, No voltage on pins

  • This topic has 1 reply, 2 voices, and was last updated 3 years ago by Ray.
Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #48539

    tomalt
    Participant

    Station 1 stopped a few days ago. Did some standard testing swapping cables, solenoid etc. All things being equal, wiring, solenoid etc it’s only when on s1 that a solenoid doesn’t open.

    Dug out the multimeter, very amateur with it so bear with me. No voltage on s1 but other stations report 0.08 – 0.11v when operating. They fluctuate between those numbers so I hope I’m reading it right. It’s the same readings across the stations that work anyway.

    Can’t see anything wrong with the ospi hardware, no obvious burnt bits.
    I don’t use a master for any stations.

    Is there anything I could have done like accidentally turned something on or off, is it likely to have just popped it’s clogs on station 1?

    #48946

    Ray
    Keymaster

    If you haven’t done so already, please submit a support ticket about this issue:
    support.opensprinkler.com

Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.

OpenSprinkler Forums Hardware Questions OpenSprinkler Pi (OSPi) Station one failed, No voltage on pins