OpenSprinkler Forums Hardware Questions OpenSprinkler Pi (OSPi) Valve is turning ON at the end of program.

Tagged: , ,

  • This topic has 1 reply, 2 voices, and was last updated 3 years ago by Ray.
Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #48441

    Esteban
    Participant

    Hi All,
    I am using the OSPi and this is the noticed behaviour:
    – A program (or run once is scheduled) Upon program start the valve doesn’t turn on. However, when the program gets to the end and is supposed to turn the valve off, the valve is turned on.
    – If the program is periodic (e.g.: run 20 seconds, every 2 min), the valve is turning off when the program starts and turns on when the program ends.
    – I tried with two different valves, of different brands (Hunter and Netafim), and also with two different OSPi boards.

    SOFTWARE: I am using the SIP python software for the OSPi.

    Does any one has seen this before? And has any clue for a solution.

    Thanks for any insights.

    elongo

    #48931

    Ray
    Keymaster

    Well, since SIP python is a third-party firmware not written by us, you have to contact the author of the firmware to find out, or you can repost this in the third-party firmware subforum.

Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.

OpenSprinkler Forums Hardware Questions OpenSprinkler Pi (OSPi) Valve is turning ON at the end of program.