Forum Replies Created

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • in reply to: Watering Schedule Corrupted #27665

    butchhandy
    Participant

    I haven’t been able to find any link to what is making it turn off yet. My only thought would be that the android app is doing it, since that is how I connect to the controller 99% of the time, and that is usually when I notice it.

    Over the holiday weekend, I will play with it some, and try your suggestions.

    More to come…

    Butch

    in reply to: Watering Schedule Corrupted #27663

    butchhandy
    Participant

    I just wanted to bring up the fact that I have had Sequential Mode mysteriously turn off on me about 5 times now over the past few months.

    I have been trying to figure out what is doing it before reporting the issue, but have not had any luck. I though it was something I was doing, but the only thing I have done recently has been to extend my rain delay a few time over the past week. Today, I went in to extend it again, and I looked at the schedule, and they were all sitting there waiting to run at 5am again. I went back into settings and turned Sequential back on.

    I basically only use the Android app to make any changes. In fact, I can’t remember the last time I logged in directly to the controller.

    So, today, I came to the forum to see if anyone else has had the same issue, and found this thread. I was going to start a new thread, but figured I would comment here first and keep things a little more organized with a possible issue.

    From the About page in the app:
    App Version is listed as 1.1.7
    Firmware is listed as 2.0.5

    Any ideas, or anything else to try? I know about Exporting/Importing my config, but that doesn’t help me when my lawn doesn’t get watered due to all the stations coming on at once. Especially bad if I don’t notice it!

    My suggestion is that Sequential should be the default. I’m sure there is a reason it isn’t, but I couldn’t think of a reason that someone would want to default all of their stations to come on at the same time, and have not water pressure to the sprinklers.

    Also, I’m not sure if it is an issue with the controller software, or with the App. I’m not sure *when* it happens. I just find out about it when either my lawn isn’t getting watered, or I go into the app and physically check the Preview Programs. I’m willing to help any way I can to track it down though.

    Thanks!
    Butch

Viewing 2 posts - 1 through 2 (of 2 total)