Forum Replies Created

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • February 22, 2014 at 6:11 pm in reply to: 1.42u Setting up Ethernet Bridge – Network Connection #24593

    david3
    Member

    Hi!!
    I solved this issue. Set BL-MP01 Switch in AP-MODE.

    When you load this configuration, the minirouter make a transparent brigde (WDS). The device connected to RJ45 receive the IP from the Wifi Router.
    Important: In SITE SURVEY connects minirouter to desired Wifi.

    If you want connect to Minirouter:
    This configuration only permit you access to router by RJ45 with IP 192.168.16.254. Set in computer same Network (p.e. 192.168.16.2).

    February 13, 2014 at 8:17 pm in reply to: 1.42u Setting up Ethernet Bridge – Network Connection #24592

    david3
    Member

    I Can to connect it!! Thanks!!
    Only add:
    In AP CLIENT menu select Enabled. After appears SITE SURVEY in left tree menu. In Site Survey Connects to Router.

    February 12, 2014 at 5:57 am in reply to: 1.42u Setting up Ethernet Bridge – Network Connection #24591

    david3
    Member

    Hello!!

    I have read your solution for converting client wifi BL-MP01, but it doesn’t work me.

    I followed your steps but I can not connect the computer on the same network.
    If I set it up the product manual (switch in Client Mode), the computer surfing the internet but not browse the local network.

    Could you export your settings and I try to make it?

    Or if you prefer, I export my settings and you correct the wrong parameters?

    Mi email is: [email protected]

    Thank you.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)