[itty2011]

Both are running 2.17 (2)

[itty2011]

Just checked and all remotes zones on the master controller are pointing to different zone index on remote controller. I would think if that was the issue, the run time would still show as the time that was set on the master controller. In this case, its set for say 15 mins on the master and instantly shows as 2 mins on remote. I’m attaching a screenshot of the 2 side by side. The remote actually started for slightly less than 2 mins.

Attachments:

1. 

   Capture.jpg
   

[itty2011]

Sorry if I wasn’t clear. I run all programs on the master controller. When i found that the zone was shutting off, I opened the remote controller to see if I had something set incorrectly and found that the station was set for 2 mins even though it was set for 30 mins on the master controller. Unchecking the “Special Station Auto-Refresh” appears to have solved the issue for now. As you mentioned, i would prefer to keep it checked if possible. Is it normal for the remote controller to show the zone set for only 2 mins? Now that “Special Station Auto-Refresh” is unchecked, the remote controller shows the zone is set for 18 hours. Is that normal?

[Author]

Posts