Forum Replies Created
-
Posts
-
Now a month on and not a single lock up/crash event. Seems like there is merit to changing port number after all.
Curious what others have experienced with this and whether this solution is not just an isolated example.
Hi,
I use an ethernet connection and experienced regular controller lockups/crashes with same outcome. I assume you could not connect to the controller at all. If so, you might want to try my solution in a similar thread.
https://opensprinkler.com/forums/topic/controller-lockups-crashes/page/6/#post-71230
Let us know how you go.
Cheers!
Hi,
I use ethernet connection and experienced regular controller lockups/crashes/freezes with similar outcome. I assume you could not connect to the controller at all when this happens. You might want to try my solution in a similar thread.
https://opensprinkler.com/forums/topic/controller-lockups-crashes/page/6/#post-71230
Let us know how you go.
Cheers!
Hi Steviooo,
I use ethernet instead of wifi and experienced regular controller lockups/crashes with same outcome. I assume you could not connect to the controller at all. If so, you might want to try my solution in a similar thread regarding ethernet lockups.
https://opensprinkler.com/forums/topic/controller-lockups-crashes/page/6/#post-71230
Let us know how you go.
Cheers!
Hi,
been having the same problems with wired Ethernet (OS3.0) like everyone else on this thread and found a solution that works for me. Appears port 80 is a bit noisy and by changing to an obscure and unused port like 8012 problem with controller lock ups have ceased. Been about 2 weeks and so far so good. Just need to make sure you change port in controller settings and forward that port in your router.
Cheers
Hi,
I am experiencing exactly the same issue. Just wondering if there was solution to this.
My setup is as follows; OS 3.0, DC version purchased about 6 months ago. Flow meter is a new (quality) device purchased at the same time. It registers 1 pulse per 10 litres and connected with shielded cable. Flow was reading accurately up until a few months after installation. Readings are now ridiculously high , i.e thousands of l/min when the system is in idle and when in use. Flow meter cable has since been removed from controller and flow is still registering flow albeit much lower i.e. range 0-300 l/min.
Just wondering how this issue was resolved with Marco83.?
