Forum Replies Created

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • June 1, 2020 at 12:41 am in reply to: Max safe current draw, concurrent run groups #66524

    m100psi
    Participant

    Thanks guys. If I wanted to run 4 zones at a time, is there a way to set up concurrent zone groups or would I need to uncheck “sequential” on all the zones, then set up separate, duplicated programs for the different zones I want to run together?

    Matt

    July 30, 2019 at 11:32 pm in reply to: Port forwarding on non-standard port #61949

    m100psi
    Participant

    Using external port 8081 and internal port 80 worked after the factory reset. Thanks for the help.

    Matt

    July 29, 2019 at 12:51 pm in reply to: Port forwarding on non-standard port #61930

    m100psi
    Participant

    OK, thank you. Will try tonight.

    Matt

    July 29, 2019 at 10:53 am in reply to: Port forwarding on non-standard port #61927

    m100psi
    Participant

    Understood, but that’s what I cannot do. It must be a restricted/reserved port for some reason as you mentioned earlier. Even from within the LAN, although I can see the device and its IP in my router config, I can’t access it using that format. So I’m looking for a hardware method to reset to default.

    Thanks,
    Matt

    July 29, 2019 at 12:37 am in reply to: Port forwarding on non-standard port #61909

    m100psi
    Participant

    Hi Ray,

    Thanks for the info. Unfortunately, nothing I do allows me to access the device on port 111 either internally or externally. How can I reset the port on the device? I tried holding B2 during startup, but it only allowed me to scroll through the saved settings.

    Matt

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)