Forum Replies Created

Viewing 9 posts - 1 through 9 (of 9 total)
  • Author
    Posts
  • April 11, 2023 at 9:03 am in reply to: Opensprinkler 2.3 DC reboots when starting station #75262

    Marco83
    Participant

    I tried replacing the DC adapter with a new unit and everything seems to be working spotless.
    So there was never anything wrong with the Opensprinkler, only with the DC power adapter!
    Thanks for the precious help

    April 8, 2023 at 8:28 am in reply to: Opensprinkler 2.3 DC reboots when starting station #75219

    Marco83
    Participant

    Thanks a million Ray!
    The controller still reboots when starting a station even if I disconnect the solenoid wires completely.
    However, I got it 100% back into business by powering it not through the DC adapter, but through the USB connection (the one used for updating the firmware).
    I would be glad to fix it anyway, what do you suggest I should replace?

    Thanks!

    April 5, 2018 at 4:07 pm in reply to: Unconnected cable sending flow data #49497

    Marco83
    Participant

    Sorry for big delay!
    If I change the sensor type to rain, nothing happens if the “normally open” box is NOT checked, but it will say “rain detected” of the box is checked. What does it mean? Thanks!

    August 1, 2017 at 7:21 am in reply to: Unconnected cable sending flow data #47360

    Marco83
    Participant

    Hello, the uncommanded input did not stop after disconnecting the sensor from the cable (!) so I trust this is an interference matter.
    Is there any way to eliminate it? I don’t know its source.

    Thanks!

    July 25, 2017 at 12:26 am in reply to: I burnt it, I want to fix it #47262

    Marco83
    Participant

    Thanks a lot! What is the resistence I am supposed to find on a working TVS diode?

    July 25, 2017 at 12:25 am in reply to: Unconnected cable sending flow data #47261

    Marco83
    Participant

    Thanks everyone!
    I believe it’s really an interference, as is still keeps sending the signal even with the flow sensor disconnected!
    How can I get rid of it?

    Thanks!!

    July 24, 2017 at 4:15 pm in reply to: View log problems in 3.0 DC with Firmware 2.1.7 #47259

    Marco83
    Participant

    I have the same issue!
    Where is the SD card located on 3.0?

    October 15, 2015 at 4:02 pm in reply to: Two flow sensors #40524

    Marco83
    Participant

    Thanks a lot Ray!
    If the two flow sensors are always used alternativaly (i.e. either 1 or 2, never together) this should help the accuracy, correct?

    Thanks again

    Marco

    April 23, 2015 at 5:30 pm in reply to: Master Valve on Zone 9-16? #37062

    Marco83
    Participant

    Hello, I have a very stupid question, I am a beginner.
    I have an Opensprinkler with 48 zones and I would like to set zone 48 as the Master.
    Mark did share with us very precious code lines, however I don’t know how to upload them into my OpenSprinkler. Do I have to compile the code? Is there a step by step procedure?

    Thanks for your help

    Marco

  • Author
    Posts
Viewing 9 posts - 1 through 9 (of 9 total)