[Networknoobie]

Hi Samer, my issue was using chrome/internet explorer/safari port 8080 would not come up or do anything.

I used a spare SD card and loaded the newest raspbian, set up wifi, and downloaded and installed OpenSprinkler and its working now on port 8080. On another note, the zone expander I have does not work at all. I have plugged it into the opensprinkler and tested one sprinkler (the green cable) on it’s line 1. I tested it using the app on station 9, and station 10.. nothing happened. I unplugged it and put it into station 1 on opensprinkler and tested it, which works fine. I don’t know why the zone expander is not working and I am not sure what to try to get it working. My setup is currently being tested and I get everything working correctly I plan on cleaning it up and making it look pretty. I appreciate any advice you can give me.

According to the about page:

App Version 1.8.0
Firmware 2.1.8 (1)
Hardware Version: OSPi

Attachments:

1. 

   test-setup.jpg
   

2. 

   test-setup-1.jpg
   

[Networknoobie]

Hi all,

I am having the same problem after updating my iphone’s app. I updated to 1.81 of the opensprinkler app and also the latest firmware for OpenSprinkler for my raspberry pi2. I could not connect to port http://opensprinkler:8080 after. I tried my laptop as well and port 8080 does not come up. I ssh’ed to my opensprinkler box to reboot it, but it still did not connect. I ssh’ed to the box again and ran:

sudo apt-get update and sudo apt-get dist-upgrade, selected yes and installed the latest updates for raspbian. I rebooted the box and still could get the default page, but nothing at port 8080. I ssh’ed again and did a pgrep to see if opensprinkler was running, it was. I killed it and went to the OpenSprinkler folder and did a git clone, and build to compile the newest version thinking that might be the problem. After it ran, I rebooted the box. I ssh’ed, made sure it has an ip address and opensprinkler is running, and tried port 8080. Still nothing. I am not sure what to do now. I am debating formatting a new SD card, getting the latest raspbian lite image, and starting my install from scratch. Do anyone have any ideas on what to try next?

[Author]

Posts