Forum Replies Created

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • in reply to: Adding pictures for zones #60957

    georgeioak
    Participant

    Along the same lines I can see station pictures with my Android phone but if I’m home and log into the OSPi directly I don’t see the station pictures. I’m logged into OpenSprinkler both on the phone and the desktop

    in reply to: Anyone Running with a New Raspberry Pi 3+? #50733

    georgeioak
    Participant

    I saw that I was running firmware 2.1.7 so I justed updated that to 2.1.8 but that didn’t help.

    If I disconnect the OS board from the Pi and run gpio readall I can see that SCL goes high so it does appear that something on my new OS Board is pulling/holding SCL low.

    Was I just unlucky and received a defective OS board?

    in reply to: New App Feature: Station Images #49267

    georgeioak
    Participant

    I just replaced my old Pi and updated everything so it’s running all the latest code. I have the OpenSprinkler app on my Android phone and when I use that I can see the station pictures. When I log into the web interface on my desktop I don’t see the station pictures. When I log into OpenSprinkler.com from the web interface it says something like this is a new site do you want to add, I say yes and it shows that I’m logged in yet no station pictures are shown.


    georgeioak
    Participant

    Just to close this thread I wanted to comment that I did a fresh install of Stretch and performed all the updates as of today (apt-get update, upgrade, and raspi-update).
    Everything seems OK so far.


    georgeioak
    Participant

    When you say update to the latest Raspian are you referring to Jessie or Stretch? I’ve been running the same system for many years and it’s running Wheezy right now. I just updated the firmware and I also can’t access the unit on port 8080 and when I default to the standard port 80 I get a page with:

    OpenSprinkler Pi (OSPi) Pre-Configured SD Card
    Oct 29, 2013

    So I’ve probably been running this system for more than 5 years.

    I updated because I’ve been working with integration into Home Assistant and the API wasn’t working properly.

Viewing 5 posts - 1 through 5 (of 5 total)